Little Monster E3D Hotend Upgrade Kit
- Product name: Hotend
- Filament diameter:1.75mm
- Nozzle:0.4mm
- Heater:24V 40W
- Thermistor: 100K NTC 3950
- Little Monster Volcano Hotend: LM hotend with BLT
PJ-00015-1
Little Monster E3D Hotend Upgrade Kit
I repoted problem with update, after several days I'm given a link to firmware update that does not work with my LIttle Monster TFT. I reported it and after two request I have not received a reply. I purchased another printer. I'm done with TEVOUP. Bad support. I'll scrap the little monster and use for other projects.
In my tevo LM kit, from the beginning there was the hotend missing (!!!) and the effector rods were not the same length. Both were resent by tevo - waiting again…. Finally I got my Little Monster complete and with all the trouble around the new BLTouch v3.1 and the firmware - without any support by tevo!!!
And now some that is making me really crazy: my Little Monster has the poorest bed adhesion I’ve ever seen on a Glas surface! - this one us my fifth delta and my 10th printer and I’m in 3d printing since 2013, so when I said it - you could trust me. Also tryed different Temperatures without any changes in the results.
I really have to buy a pei sheet to get the prints sticking on the bed. Yesss - another 70 bucks - thx tevo 👍🏻
I ordered a replacement hot end for my Tevo Little Monster. The one I received does not in any way fit in my printer.
Hi Frode,
That is because you ordered the Tarantula RS replacement hot end NOT the Little Monster hot end, so it can not fit your Little Monster printer. You can find the Little Monster hot end kit here: https://tevoup.com/products/tevo-3d-printer-hotend-for-tarantula-hotend-sets-for-tornado-volcano-hotend-for-little-monster-for-flash